| |
 |
|
The box is made from black acrylic with a comb separator molded in on each side. Includes 20 model A, T, H, I, X or Bar display cards. You can also customize your box by ordering an empty box and the cards you need. The display cards are made of black scuff resistant chip board and laminated with your choice of black, blue, or burgundy velour on one side.
WHICH STORAGE BOX TO ORDER?
- Determine model of your AirTite coin holders by diameter or coin type (check charts below)
|
| AirTite Model |
Outside Diameter |
| A |
1.22" / 30.94mm |
| T |
1.44" / 36.9mm |
| H |
1.75" / 44.45mm |
| I |
2.03" / 51.59mm |
| X |
2.12" / 53.80mm |
|
| Coin Type |
AirTite Model |
| |
Direct Fit |
Ring Type |
| Cent |
A |
A |
| Nickel |
A |
T |
| Dime |
A |
A |
| Quarter |
A |
T |
| Half Dollar |
T |
H |
| Small Dollar |
A |
H |
| Silver Dollar |
H |
I |
| Silver Eagle |
H |
I |
|
Storage Box assembly:
Assembling the Air-Tite holder and storage box card is simple. Place the holder on a flat surface and press the display card over it with the embossed paper side facing the holder and the velour side facing you. Apply pressure until the holder is flush with the back of the display card, the paper side is slightly beveled to assist in assembly. Slide the card into the Storage Box. If you need to remove a holder, carefully push the holder out from the backside of the display card so that it comes out on the embossed paper side.
|